Description
Cleaning your nozzle is NOT fun without the right tool.
This kit can be used to clean your nozzle without removing it from the printer. Simply heat the nozzle up to 20 degrees higher than normal for the filament type that is stuck, then insert the cleaning needle into the end to dislodge the blockage. Thereafter, extrude several cm of filament to see if the problem is solved. A good, clear nozzle should extrude a clean cylinder of filament, in a straight line down. If it curls sideways, you still have a small blockage.
Features
- x8 nozzle cleaning rods
- x6 @ 0.35mm & x2 @ 0.15mm
- Enlarged & flexible grip for easy use
You will receive:
x6 0.35mm needles
x2 0.15mm needles
x1 Case to secure them
